Manual Paint Colorant Dispenser User Manual

  

Aaron Equipment buys, sells, and trades Used- Harbil Manual Paint Colorant Dispenser, Mod. Submit a quote for this Hopper Blending Feeding Equipment or call 630-350-2200 for more information. Hero d23prm12f0204e Is Similar To: 242592 Hero Colorant Dispenser Archimede (61.2% similar) Brand new never used comes complete with everything in photos ready to use all specs on this item are my check them out.(posted on April 24th, 2017); Hero 24sr12co204e Colorant Dispenserl Paint 2000 (51.6% similar). This item has had paint in 2 of the 12 canisters.

  1. Paint Colorant Dispenser
  2. Manual Paint Colorant Dispenser User Manual Software
  3. Manual Colorant Dispenser

Page 12: Weekly maintenance, General maintenance, If a col, It is

Advertising

10

15

HARBIL DUAL PUMP COWR DISPENSER

MAINTENANCE

1. DAILY MAINTENANCE

Agitate the colorants as required every morning. The actual amount of agitation

time can be determined by your own experience with the colorants. On dispensers
equipped with manual agitation this would normally be about ten to fifteen turns
of the agitator knob every morning, although this may vary from colorant to
colorant. Dispensers equipped with motorized agitation would normally be run
for approximately fifteen to thirty minutes.

Check the level of the colorant in all of the canisters and if the colorant level is

down to one-half of the lower agitation blade, add a minimum of two quarts of
colorant. The correct operating amount of colorant in each canister should be
from one-half quart to six quarts.

Wipe all of the nozzles clean with either water or mineral spirits, depending on

the type of colorant being used (DO NOT USE MINERAL SPIRITS FOR
WATER OR GLYCOL BASED COLORANTS, as this will cause damage to
the O-Rings on the Valve Assembly).


2. WEEKLY MAINTENANCE

Dispense a full measure of any colorant that has not been used during the week

into an empty receptacle and then pour it back into the canister (as described in
GENERAL INSTRUCTIONS-Section 5, AGITATING THE COLORANTS
on page 8).


3. GENERAL MAINTENANCE


IMPORTANT:

If the dispense nozzle of the pump should become clogged the insertion of a paper

clip or other similar object will clean out any obstruction in the nozzle. However,
before doing this, the DISPENSING VALVE LEVER MUST BE OPENED
(pulled forward) as in dispensing. BE SURE TO REMOVE the paper clip before
closing the valve lever.

If a col

orant leak develops at the top of the dispensing pump or there is colorant

on the piston rod, a one ounce or five ounce Pump Repair Kit (part no. 4223112
and 4223502 respectively) should correct the problem. If after replacement of
the Pump Repair Kit the problem still persists, the inside walls of the pump
tube may be scored and the pump tube will have to be replaced.

It is

recommended that one or two pump repair kits be kept in stock for

emergencies.

DUAL PUMP 192 OZ. CANISTER PUMP ASSEMBLY


ITEM

PART NO.

DESCRIPTION

NO. REQ.

4209000

Canister Pump Assy. w/o Agitator & Cover.192 oz. U.S.

1

4209002

Canister Pump Assy. w/o Agitator & Cover.192 oz. Metric

1

4209003

Canister Pump Assy. w/o Agitator & Cover.192 oz. Imp.

1

Colorant

4209060

Canister Pump Assy. w/o Agitator & Cover.192 oz. U.S.

1

6MM Exit Port

4219000

Canister Block & Sleeve Only,192 oz.

1

4219060

Canister Block & Sleeve Only.192 oz., 6MM Exit Port

1

1

4000008

Knob, Black, #25.5/16-24 TH

1

2

4228501

Knob, Black.#44.3/8-16 TH

1

3

4000018

Screw, Set, 8-32 x 3/16, Socket, C/P

5

4

4226-

Gauge Assembly Complete.1 oz.

1

Paint Colorant Dispenser

Colorant

5

42265-

Gauge Assembly Complete.5 oz.

1

6

4228100

Gasket, Pump Tube.1 oz.

1

7

4228502

Gasket, Pump Tube.5 oz.

1

8

4235004

Lever. Valve, 5 oz.

1

9

4235005

Pin, Roll, 1/8 x 1-1/2, SS

1

10

4235000

Valve, Lever Assembly Complete, 5 oz.

1

10

4235601

Valve, Lever Assembly Complete.5 oz. (6MM)

1

10

4235501

Valve & O' Ring Assembly.5 oz. (Viton)

1

10

4235507

Valve & O' Ring Assembly.5 oz. (Thiokol)

1

11

4235006

O' Ring, Valve, Viton.5 oz.

2

11

4235007

O' Ring, Valve, Thiokol, 5 oz.

2

12

4000061

Screw, PHCS.10-24 x 3/8 Slot, C/Z

1

13

4235013

Retainer, Valve, Lever. 5 oz.

1

14

4235011

Plunger Valve Stop

1

15

4000150

Nut, Hex.1/4-28.Jam

1

4000108

Nozzle, Cap and Pad

1


Kits

4290502

Kit. Canister Repair.5 oz.

• U.S.

4223502

Kit.Pump Repair.5 oz

•• U.S.

4223112

Kit.Pump Repair.1 oz

•• U.S.

4235014

Kit. Valve Repair.5 oz

.• Single Exit

4235015

Kit. Valve Repair.5 oz

.• Double Exit

Advertising
Popular Brands
Popular manuals
After all of the canisters have been installed on the turntable, they can be
filled. Each canister has a maximum capacity of 2-1/2 quarts. It is
recommended that each canister be filled with two (2) quarts of colorant.
The maximum capacity of the pump is two (2) ounces.
The following steps represent the process by which the canisters should be
1. Locate the first canister and determine which colorant is to be placed
2. Place the appropriate decal on the canister.
3. Shake of stir the colorant following manufacturer’s recommendations.

Manual Paint Colorant Dispenser User Manual Software

4. Slowly, pour the colorant into the canister to the level of approximately
6. Repeat these steps for each of the remaining canisters.
7. After all of the canisters have been filled, agitate by turning on the
agitation motor. This will release any air trapped in the colorant.
Once the canisters have been both filled and agitated, the pumps attached to
each of the canisters must be properlyprimed. Follow these steps to prime
2. Slowly pull the pump handle all of the way to the top of its stroke and
wait in this position for a count of approximately three (3) seconds.

Manual Colorant Dispenser

3. Slowly press the pump handle all of the way down to the bottom of its
5. Repeat steps 1 through 4 for each of the remaining canisters.