- Reconnect Bth Bt-s-mic User Manual Guide
- Reconnect Bth Bt-s-mic User Manual Download
- Reconnect Bth Bt-s-mic User Manual 2017
- Reconnect Bth Bt-s-mic User Manual Free
Product offers and availability are subject to change. All prices are inclusive of taxes. Product colours & images are only for illustration and they may not exactly match with the actual product. Kinivo BTH360-S Bluetooth Stereo Headphone manuals and user guides for free. Read online or download in PDF without registration. The user know the current status of the PRYMEBLU Headset. PRYMEBLU ® BTH-200 Bluetooth Headset with PTT capability The PRYMEBLU BTH-200 is a wireless Bluetooth headset with Push-to-Talk capability, for use with PRYMEBLU two-way radio adapters. PRYMEBLU BTH-200 Made in China PRYME® and PRYMEBLU® are trademarks owned by PRYME Radio Products.
16
NO LOW VOLTAGE (Figure 20)
24V AC LED Off
NO LOW VOLTAGE, 24V AC LED Off
FIGURE 20
TEMPERATURE PROBE FAULT (Figure 21)
Water Temp LED Flashing
TEMPERATURE PROBE FAULT, Water Temp LED Flashing
FIGURE 21
This condition accommodates multiple failure modes. To more accurately
determine the cause of failure, press the pushbutton on the display board.
Reconnect Bth Bt-s-mic User Manual Guide
FAULT CONDITIONS
The controller is set up to provide additional status indicators under Fault
Conditons. The following figures are possible Fault Conditions.
NO INCOMING LINE VOLTAGE (Figure 19) Line LED Off
Possible Cause
Remedy
1.
Burner ground wire broken
1. Check wire and connection
or corroded
at burner
2.
Connectors unplugged
2. Check connections
3.
Reconnect Bth Bt-s-mic User Manual Download
Igniter broken
3. Replace igniter
4.
Flame probe faulty
4. Replace flame probe
Reconnect Bth Bt-s-mic User Manual 2017
5.
Gas shut off
5. Turn on gas supply
6.
Clogged gas valve
6. Replace gas valve
7.
Faulty gas valve
7. Replace gas valve
8.
Defective control
8. Replace control
9.
Burner improperly adjusted
9. Adjust burner
10.
Dirty burner
10. Clean burner
GAS VALVE LED FLASHING
This condition results from a failure to establish burner ignition after three
successive trials. In such cases:
1. Investigate the possible cause and remedy any observations.
2. Momentarily depress the button on the display panel to reset the lockout
condition.
3. Confirm proper appliance operation.
NO INCOMING LINE VOLTAGE, Line LED Off
FIGURE 19
Reconnect Bth Bt-s-mic User Manual Free
Possible Cause
Remedy
1. No Input Power
1. Apply Power
2. Wiring Disconnected
2. Check all wiring
3. One or more wiring receptacles
3. Reconnect plugs on control,
disconnected from control
confirm all are fully seated
4. LED burned out
4. Ignore or replace control
Possible Cause
Remedy
1.Blower 24 VAC Fuse
1. Replace 24 VAC 3a Fuse
(Littlefuse 257003 automotive fuse).
2.Defective Transformer
2. Replace Transformer
3.LED burned out
3. Ignore or replace control